The direction of the arrow always points from the positive P-type region to the negative N-type region for both transistor types, exactly the same as for the standard diode symbol. The construction and circuit symbols for both the PNP and NPN bipolar transistor are given above with the arrow in the circuit symbol always showing the direction of “conventional current flow” between the base terminal and its emitter terminal. As a small current flowing into the base terminal controls a much larger collector current forming the basis of transistor action.
These three terminals are known and labelled as the Emitter ( E ), the Base ( B ) and the Collector ( C ) respectively.īipolar Transistors are current regulating devices that control the amount of current flowing through them from the Emitter to the Collector terminals in proportion to the amount of biasing voltage applied to their base terminal, thus acting like a current-controlled switch. The Bipolar Transistor basic construction consists of two PN-junctions producing three connecting terminals with each terminal being given a name to identify it from the other two. There are two basic types of bipolar transistor construction, PNP and NPN, which basically describes the physical arrangement of the P-type and N-type semiconductor materials from which they are made. The word Transistor is a combination of the two words Transfer Var istor which describes their mode of operation way back in their early days of electronics development. Cut-off – the transistor is “Fully-OFF” operating as a switch and Ic = 0.Saturation – the transistor is “Fully-ON” operating as a switch and Ic = I(saturation).Active Region – the transistor operates as an amplifier and Ic = β*Ib.Then bipolar transistors have the ability to operate within three different regions: The transistor’s ability to change between these two states enables it to have two basic functions: “switching” (digital electronics) or “amplification” (analogue electronics). Transistors are three terminal active devices made from different semiconductor materials that can act as either an insulator or a conductor by the application of a small signal voltage. The fusion of these two diodes produces a three layer, two junction, three terminal device forming the basis of a Bipolar Junction Transistor, or BJT for short. If we join together two individual signal diodes back-to-back, this will give us two PN-junctions connected together in series which would share a common Positve, (P) or Negative, (N) terminal. The bipolar transistor uses one more layer of semiconductor material to produce a device with properties and characteristics of an amplfier. Unlike semiconductor diodes which are made up from two pieces of semiconductor material to form one simple pn-junction.
0 kommentar(er)
